The design of vacuum arcing chamber and insulation support sheath pipe is compact, because the outlet line conduct pole is coated silicon rubber, it can be suitable for bad weather and pollution environment. 真空灭弧室和绝缘支柱套管设计紧凑,出线导电杆外注硅橡胶,能适应恶劣的气候条件和污秽环境。
Compact structure, small occupation, inlet and outlet on the same horizontal line, and easy installation. 进出口在同一条水平线上,安装方便。
The test results have proved that the flow rate widely varied and the pump efficiency is high when the pump outlet line structure was altered and the outlet pressure was controlled in a special limit. 试验结果表明,改变泵出口管线结构,使泵出口压力在一定范围内工作时,流量变化大,而且泵效率较高,可以作为泵调整参数的一种手段;
Flush the coolest product stream outlet to blowdown or pumpout system to water free the line and exchanger. 从出口冲洗温度较低流体侧,使交换器与管道中没有水。
The shell is arranged with an outlet line channel therein, the electric wire outlet direction of which is perpendicular to the electric wire inlet direction of the first connection tie. 所述的壳体内设有出线通道,所述出线通道的电线接出方向与所述第一接线头的电线接入方向垂直。
Verify the manual valve and outlet valve on the hot oil line of100RA101 are open. 确认100RA101的热油管线上的手动进口阀和出口阀打开。
Numerical Simulation of Excavation And Support of the Outlet of Longtan Tunnel Right Line 龙潭隧道右线出洞口开挖与支护数值模拟
The experiment and construction of the backfill grouting on the earth section of outlet of No. 3 tunnel in the South Main Line are introduced. The construction procedure, construction method, construction parameters and technological requirement are summarized for practising backfill grouting in non collapse earth tunnel. 通过对引黄南干3洞出口土洞段回填灌浆的试验与施工,总结了在非湿陷性土洞中,实施回填灌浆的施工程序、施工方法、施工参数及技术要求。
Construction Technique of Earth Tunnel at Outlet Section of No.6 Tunnel In the South Main Line and Analysis on Its Contract Project Time 引黄工程南干6洞出口段土洞施工技术及合同工期分析
Analysis on the Reason of Crack in the HAZ of Weld Connecting Flange and Pipe of Outlet Line in Alkaline Tower 碱洗塔出口法兰与管线焊缝热影响区产生裂纹原因
Decreasing the refrigerant super-heating degree at the outlet of the suction line heat exchanger can reduce the evaporator size, but it simultaneously increases the refrigerant mass flow rate and compressor power. 降低制冷工质在回热器出口处的过热度,可以减小蒸发器的尺寸,但由此带来的不利因素,是需要增加制冷工质的质量流量以及提高压缩机的压缩功率。
Technical innovation on additional outlet shear device at shearing line 剪切线新增出口横剪装置的技术改造
The calculation of the outlet velocity of pressure vessel jet and the nozzle-duct system are led into the gas line pressure test, and the relationship between the test pressure Ps and the pressure drop [ △ P] has been obtained. 把受压容器喷出口的流速计算和喷管&直管体系引入煤气管道的试压过程,得到试验压力Ps与允许压力降[△P]间的关系。
Expounding for Predicting the Flood Processing in the Outlet of the Basin with the Unit Line Method 单位线法推求流域出口洪水过程综述
By laser cladding, the sealing face of the in outlet valve parts in methylamine pump in urea production line has been strengthened. 采用激光熔覆技术对尿素生产线上的甲胺泵进排液阀零件密封面进行强化。
DML Overhead Outlet Line Finder for Fault Position DML架空线故障点寻迹仪
Piping Stress Analysis-Inlet and Outlet Pipe line Design for Steam Turbine Compressor 管道应力分析&蒸汽透平压缩机进出口管线设计
Composing a reliable and high-effective access networks must solve the problem of high frequency signal bypassing the transformer and passing the outlet of the broken broker and the interface between the PSTN, Internet and power line grid. 要组成可靠、高效的信息接入网,必须解决高频信号翻越变压器和跨越断路器断口的问题以及与电话网、计算机网络接口与组网方式问题。
Causes Analysis on Some Strants of Outlet Line Broken on Tension Pole 耐张杆塔引流断股原因分析
The results show that only when the fitting of various technique factors, pressure head, outlet temperature, pulling speed and cooling condition is reasonable under a certain range, can the ZA alloy smooth line be continuously pulled out. 结果表明:只有金属液压头、型口温度、拉铸速度和冷却条件诸工艺参数在一定范围内的协调配合,才能拉铸出表面光滑的锌铝合金线材。
Combined with electrical current thermal effect principle, the reasons of some strants of outlet line broken on tension pole in Hengshui 110 kV power transmission line are analyzed, and the prevention improvement are presented. 根据电流的热效应原理,分析了衡水110kV送电线路耐张杆塔引流断股的原因,提出了预防改进措施。
A Bond Graph Model of Inlet Flow and Outlet Flow for the Distributed Parameter Fluid Transmission Line and its Experimental Research 输入流输出流管道分布参数键图模型的建立与实验研究
The cause why the crack occurred in the HAZ of the weld connecting flange and pipe of outlet line was analyzed. 对某厂碱洗塔出口管线的法兰与管线焊缝热影响区产生裂纹的原因进行了分析。
Under the circumstance of high load, to keep the normal operation, hot EG washing are used timely to wash the outlet of vapour, the direct condenser vapour line plug can be avoided. 在高负荷下,为保持正常运行,用热EG定时冲洗升气管口,可以避免直接冷凝器升气管的堵塞。
A new principle is adopted in designing low pressure MOCVD equipment. The principle is that the pressure is set and controlled separately in outlet and inlet of gas line of mass flow controller. 采用了一种新的设计原理,即以流量计为基准,将气体入口端和出口端压力双重分别统一控制,进行了低压MOCVD设计。
With the new type of vortex quick separator in FCC riser outlet, gas-solid flow spraying out at tangent line to vortex separator forms a strong vortex flow field, so solid particles can be separated efficiently from the gas. 催化裂化提升管出口新型旋流式快分利用气固沿旋流头切向喷出时形成的强旋流实现快速的气固高效分离。
Set the water outlet along the route pass by, the TOPAZ model can determine the catchment area of the line, so it is easy to calculate the preliminary design of drainage facilities, combined with the HY-8 models, complete hydraulic analysis of the facilities. 在路线所经过水系位置设置出水口,TOPAZ模型可确定路线局部汇水面积,可初步计算得出该段排水设施的设计流量;结合WMS的HY-8模型,对设施进行水力分析计算。